Review on 🔥 Labwork 8X Gray 1200° Spark Plug Wire Boots Heat Shield Protector Sleeve for SBC BBC 350 454 - Ultimate Thermal Protection for Engine Performance by Lagant Wardrick

Cool product, looks good, does the job and for the $ it's worth the short time it takes to make the necessary adjustments to make it fit . 2008 C6 LS3, standard plug and cable. One end of the sock is sewn, the other end is bent onto a metal gasket and tucked into the sock. The metal O-ring itself is slightly smaller than the rubber boot that goes to the coil pack. To make this work I had to open the sock at the end of the o-ring and ignore the metal o-ring, then thread the heat shielded spark plug wire through the sock, and then fold the unsewn end back into the sock (just because there were fewer metal rings to begin with gave) . If it was plug and play it would be 5 stars. I hope it helps.