Review on Power supply DC 12 Volt 360 Watt 30 Amp. LED strip power supply model S-360-12 by Vassil Yanakiev ᠌

The power supply 12v at 30A is quite a powerful device! It can be used for various purposes where 12 volt equipment is required. If there is a slight growl or zero drift in powerful consumption, this means that the block is needed even more powerful or an additional electrolyte conder should be added at the output. I don’t advise too large a capacity, because when the power supply itself is turned on, the output may be in a mode close to a short circuit and the unit may go into protection mode or burn out completely. I took it instead of the laboratory one - it's much cheaper and more powerful. There is a fine adjustment control. At the output, I will use a 22022uF capacitor at 50V. So, which is suitable for various solutions in your experiments! Moreover, the laboratory unit produces no more than 10 amperes, and here 30 amperes ! ! Of course, there is no regulation from 3 volts to 12 volts, but this problem can also be improved, fortunately, there is the Internet and everything is clearly and clearly explained there, how and what can be done. I took 2 pieces, if you have to increase the power, the main thing is to strictly observe the polarity of the output connections. If you make the outputs of the first with the second in series, then there will be 24 volts and 30 amperes. If parallel connection, then there will be 12 volts 60 amperes ! ! In terms of power, you need to select with a margin, since the power supply can produce a little less current than it is characterized in its technical description. Therefore, the load must be given less than 30 amperes in current, at the same time the unit will not overheat so much. Good luck everyone!