Review on Splash Guards Fender Flares Wrangler by Anthony Cayton
Instructions Primed and DRILLING REQUIRED
Drilling Required Front requires drilling a hole in the plastic inner fender. In the rear, the factory screw is not long enough to fit with the fender (screws not included), also in the rear there are no holes in the rear bumper, so 3 holes need to be drilled on each side. Plastic rivets are cheap, found 3 faulty ones, be sure to buy extra, in general it's not that bad, but the color is dark black, and the bottom is more gray.
- Exterior Accessory
- Zero
New products
Comments (0)
Top products in 🚗 Mud Flaps & Splash Guards
Another interesting products
SuperJump Trampoline with SuperJump 8ft (244 cm) net and ladder
29 Review
Get Ultimate Towing Stability With CURT TruTrack Weight Distribution Hitch & Sway Control - Up To 10K Capacity, 2-Inch Shank & 2-5/16-Inch Ball - In Sleek Black Design
30 Review
Cordiant Road Runner 195/65 R15 91H summer
24 Review
ORCISH 12V 13000-lb Load Capacity Electric Truck Winch Kit 🚚 with Synthetic Rope - Waterproof Off Road Winch for Jeep, Truck, SUV
35 Review