Review on 96101KP Bowtie Grille Tailgate Emblem by Dick Grayson

The front is easy to install. It doesn't quite match the factory emblem. It's a bit bigger, which is why I only gave it 4 stars. Although it looks ok. The front emblem is screwed on after you remove the factory part with a flat head screwdriver. Just be careful not to over tighten. I tightened it by hand and then twisted it with pliers. The rear emblem is a little tricky. You will need to use either a heat gun or a blow dryer to loosen the factory glue. If you overheat it you will damage the paint. The new piece is simply glued in place after you remove and clean the old glue.