Review on High-Performance Pedro A Bailey Carburetor for Briggs & Stratton 498298 692784 495951 492611 490533 495426 Carb with Enhanced Pads by Eddie Sanchez

About as cheap as a gasket kit. Couldn't install gasket because my carb just fried. This is made for engines with deeper tanks but I was able to trim it. The screw on the side does NOT regulate the air/fuel mixture. It's literally a jet plane. It cannot adjust the fuel-air mixture. It worked well enough for my engine. However, the throttle body was covered in rust when I received it. It won't cause any problems, but it's still not very pretty to look at. Fits directly to my 3HP Briggs. I think it's a late 80's model. Came with a tank gasket and head gasket to the carburetor. The processing looks pretty good. I found a student mark inside below where they installed the idle circuit jet. Worked better than expected for my application and at a very low price for a new carburetor so can't complain.