1 Level
1282 Review
48 Karma
Review on π§ Compression Fitting Connector by Anderson Metals by James Holker
Luckily I found this fitting
Needed something to change from 1/4 hose to 3/16 compression and it fit. I use this on an airbrush, I have a 3 gallon compressor with standard 1/4 quick disconnects. bright.
Pros
- . This fitting contains lead and federal law does not permit its installation in drinking water supplies in the United States and its territories.
Cons
- Only available in white
New products
Comments (0)
Top products in π§ Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
4.36
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
3.88
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
3.86
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
3.75
13 Review
