Review on Wall bracket ONKRON SN14 for TV 32"-65", inclined, up to 68 kg, black by Stanislaw Banasiuk ᠌

The bracket is good. I hung a 43" TV on it and then bought exactly the same bracket for the future 65" TV. The main points to pay attention to when hanging the TV for the first time (I had to re-hang). Hung TV LG 43 "series 8100. 1. Don't trust the bubble level on the bracket. The result will be in error. It is best to use a laser level. Aligning the wall mount exactly in level is very important for this type of bracket, because you cannot change the angle of rotation of the TV on an already mounted bracket. 2. For the first time, I hung up the TV with plastic spacers and M6x35 screws that came with the kit. I didn’t like it - because of the spacers, the gap between the wall and the TV unreasonably increased. As a result, I bought additional M6x20 screws and hung the TV without spacers. 3. Pay attention that when attaching the two rails to the TV, the stickers with the inscription "LOCK" on the rails are on the outside, otherwise you will not be able to tighten or loosen the screw, which is responsible for adjusting the tilt of the TV and for blocking it in a certain position. This may be necessary in some cases, but for adjustment you will have to buy an extension cord for a screwdriver, otherwise you won’t crawl through - your hand won’t crawl through. The first time I did not pay attention to this and confused the guides in places. 4. No plastic tabs need to be cut off (as instructed). with their help, the TV is dismantled from the mount. The tongues are easily hidden behind the TV, and you can cut off the wrong thing at all and make yourself unnecessary problems. 5. The diameter of the holes on the guides through which the bolts are screwed into the TV is slightly larger than the diameter of the screws, which is logical. Therefore, when you tighten the screws, pull the guides as far as possible towards the upper generatrix of the TV and tighten, otherwise you will most likely get skewed. In general, the bracket is cool and reliable. Since the walls are made of gas blocks, for greater reliability, I bought 10x80 mm dowels and 100 mm hex plumbing bolts. I recommend.