At first the meter was very attractive and I used it a lot. I once unfolded the small stand on the back of the instrument to hold the meter upright. When I pulled back the little stand. It just broke at the pivot. The second thing I noticed was that the positive (red) connector was getting very weak and not making good contact with its counterpart on the test lead. Bad situation when measuring low current. The third and final straw that broke the camel's back was that the power button became very unstable and in many cases wouldn't even stay on. I looked to see if I could clean the contacts but the entire assembly was obscured and there was no way to apply any type of contact cleaner inside the switch assembly. At this point I should start looking for a replacement.
Upgrade Your Car Diagnostics With 16 Pin OBD2 Extension Cable Splitter - Male To Dual Female Y Cable - 50CM
17 Review
Vgate ICar Pro Bluetooth 3.0 OBD2 Code Reader OBDII Scanner Scan Tool Car Fault Diagnostic Check Engine Light For Torque Android
22 Review
Autel AP200H OBD2 Scanner Dongle - Wireless Bluetooth Code Reader with Health Status Reports - Diagnostic Tool for Engine, Transmission, ABS, SRS - OLS/BMS Resets - All Vehicles (Android/iOS)
11 Review
eTORK 3/8-Inch Drive "Click Style" Electronic Torque Wrench: Precise Torque Control (25-250 In. lbs., 2-20 ft.-lb.)
12 Review