Review on 🔧 Enhanced XSPC Easy Cut/Easy Bend PETG Liquid Cooling Tool Kit by Kenny Beyer

The angles on the bender don't include a 45 degree mark which I think should be included. I actually stopped using the bending tool because I found it was too tedious. I couldn't get the pipe cutter to ever cut the pipe cleanly. Always cut at an angle which was annoying. I tried cutting a variety of ways but couldn't get an even cut. The insert is not very good. Even with soapy water it was almost impossible to pull the liner out of the 90 degree bend. I had to pull so hard on the pad that it stretched forever! Now I have to be careful not to put the stretched part inside the bend when shaping, otherwise the bend won't be formed properly. I really advise against buying this. Properly used for XSPC PETG tubes with 10mm ID and 14mm OD. I can't believe people didn't check something so obvious before buying. Also note that if done by the same company, it will work for their products and is not guaranteed to work for others.