1 Level
1357 Review
69 Karma
Review on ๐ฉ HHIP 3701 0138 Drill Chuck with ARBO Compatibility by Tim Paolucci
Work in progress
While it looks good I found the drawbar hole and thread were over 1/4 less than my other R8's -Collets which prevented full seating/snapping.With some effort I was able to build up a 7/16-20 thread but I still had to trim the tongue to make this collet usable.It was cheap and needed corrections left me with a workable collet, which is why I'm giving it two stars.
Pros
- Drawbar end thread: R8- 7/16"-20
Cons
- I don't remember but there was something
