1 Level
1271 Review
59 Karma
Review on πΆ HHIP Flute Speed Double (Model 5803-0375) by Bud Crabtree
Dull like slop for end mills
Side milling performance is terrible. When toggling straight from a good bit at the right speeds and feeds, this end mill created a huge burr on the 6061 and was more scrolling than cutting. This is where you get a negative value because not only does it not cut, it ruins otherwise good material.
Pros
- Used for slotting, grooving, grooving and plunging
Cons
- I don't remember but there was something
