Review on 🔒 Bull Ring Stainless Steel Flush Fit Retractable Tie-Down Anchors for 2009-18 & 2019-20 Dodge Ram Rear Holes Model 4066: Polished Stainless Cover Rail Cap with Alteration Requirement by Ryan Frawley

A bit of work if you decide to use a shop knife to trim the plastic to fit. If you don't have much time to install, buy a bit kit sold by Bull Ring. I used a shop knife and it took about 10-15 minutes to cut each whole piece, cut a little with a trial fit, cut a little with a trial fit. Note: Just because your stake holes are already cut - they won't fall off easily, you'll need to trim back the sides and ends of the hole (plastic) to allow for the crome border on the bottom (see photo with the screwdriver pointing in direction ). edge) so that it passes through the hole and fits snugly against the surface of the rail. I also had to loosen both screws to seat the assembly, then tighten the ring and tighten the screws - finger tight. Don't cut yourself trying to grab the knife and wear safety goggles (if the blade breaks). Looks good, I recommend.