Review on 📺 Enhance Your TV Viewing Experience with Mounting Dream Full Motion TV Mount: Fits 26-55 Inch TVs, Includes Socket Wrench & HDMI Cables, Supports VESA 400x400mm and 60lbs, MD2377-KT by David Bott

I originally wanted a dual arm mount but of course the bolt was right in the middle where I needed to mount the TV. My TV weighs 53 pounds and I doubted it would be enough, but it worked. Please note that if you are using a TV with a VESA 40x40 mount, you will NOT have horizontal adjustment. This was a problem for me as the mount is manufactured so that the center line of the wall mount is a few inches from the center line of the TV and I had to have it right in the center of the stand. I ended up attaching the TV plate to a bracket a few inches larger using the extra hardware I had. In general, the result was very good. When you move the TV, it wobbles a bit, but once installed it stays in place. The set is carefully supplied with an HDMI cable, spirit level and screen cleaning kit. in the center of the stud that the bracket is attached to. Remove the four Allen screws securing the TV plate to the bracket. They are screwed into nuts that are welded to the plate. You will need two nuts + washers to match these bolts. With the front of the assembly facing away from you, move the plate to the right so the left arm holes line up with the two right weld nuts on the plate and loosely thread in the two screws. Insert the other two bolts into the right hand holes in the arm and through the slot in the plate and tighten the two nuts and washers. Align the two parts and tighten. Aligning the TV is still easy, you just need to slightly loosen the two left screws that go into the welded nut to get the slightest play to level the TV - no need to loosen the right screws (not for me anyway ). Hope this helps someone.