Review on 🔎 ESUN 1.75mm 3D Printer Filament Spool - Optimize Your Search by Gregory Chaitanya

ASA is difficult to process on most printers so I can't say it gives me some problems but it was just an adhesion issue and I found that there was a layer of tape on the Print bed has fixed it up too. What I don't like about this role is that it's too small. I'm not talking about the weight, I know how much I ordered. I'm talking about a real coil. The sides don't protrude far enough beyond the thread wrapped around them, so I had trouble unwinding it. I really had to keep an eye on my prints of the first few layers on the spool to make sure the filament didn't pop off and wind up on the spool holder.