Review on 🌸 LSS 10 10.2 inch Laptop Skin Cover - Compatible with HP Dell Lenovo Apple Asus Acer Compaq - Abstract Floral Pattern (Includes 2 Free Wrist Pads) by Kenneth Barnes

Well nice decal yes. It's also very easy to install (if you get it right. I didn't get it right at first and I'll get to it). There is a chart on the back to help you understand everything which has been great for me as I can't draw or cut a straight line even if my life depends on it. I was disappointed to see the decal came as one large piece. I was under the impression that there would be a large part for the front panel and a part for the keyboard area but it wasn't, it's just an enlarged image of what you order (I order a purple lotus flower with a black background) . ). I assume you have to use the leftover pieces of the sticker to use it on the keyboard? Well, in the picture I chose, it's nothing but black remains with a squiggly line here or there. The header image shows a thumbnail of the same front panel image that can be used as a keyboard sticker, but it's not a thumbnail, it's just a big image (not even a big image and a small one). That being said, it's literally one big enlarged image) so be aware you won't get a second image. Now for the installation. there's a right and wrong way to do it (I got it wrong the first time and it annoyed me so much I had to pull it off and do it right). So if you are a perfectionist like me you don't need a lot of bubbles under the decal and if you just put it there and go for it you will have a lot of bubbles under the decal visible in every view. Light hits the sticker. When sticking the sticker, it's best to start on one side (top or bottom, left or right, it doesn't matter, just start on one side) and use a credit card or something flat and hard (small box side, remote control side, or the side of your phone as I have used) and while holding one end down evenly, use a credit card or whatever you are using and press down on the rest of the sticker while pressing firmly (but not so hard that the computer breaks down) and press the sticker piece by piece with the item you are using. Once you've applied the entire sticker, start in the center and again, using your flat object, press firmly from the center outwards until you have the entire sticker down and there are no more mini-bubbles. Then take your item and really seal the edges. Well, and voila, you have a nice bubble-free seal and don't have to worry about chipping. However, I already have a small curl on one corner of my decal from having to peel and reapply it because I didn't get it right the first time. I've had a lot of these stickers for my laptops and each one lasted more than a year (so I should have known better than just sticking it in there. I think the keyboardless sticker was my brain elsewhere so I don't pay for it as usual) . I brought a sticker from Mighty Skins (which is what I usually use because it doesn't need to be cut, fits perfectly on the computer you are using and it also has a keyboard sticker and it covers the whole area which gives a nice sharp edge look yields when everything is ready) this sticker was cheaper and will arrive sooner so I wanted to try it but it didn't look anywhere near what I'm used to so personally I won't buy again for a laptop. I would buy for other things but not for my electronics. I like things that fit and look good (I'm not a big fan of the "you can tell I cut this out and tried to fit my computer" look).