Review on Dorman 973 023 Resistor Chrysler Sebring by Will Anderson
Much better! at Blower Motors
Much better quality than the flimsy crappy PCB used for the OEM resistor. I have no doubt it will last much longer than OEM. YES, you will need to cut a hole to fit this part. Not so hot what's up. I used a wood drill bit on my drill bit and it worked perfectly. Dremel would be perfect. Be sure to slide the red tab on the back of the connector with a small flathead screwdriver. Then press and pull the black tab to remove it.
- Absolutely amazing!
- Blank
New products
Comments (0)
Top products in 🌡️ Engine Cooling & Climate Control
Another interesting products
2007-2017 Jeep Wrangler JKU 4 Door Sunshade Mesh Top Cover - Durable UV Protection With US Flag Design - Voodonala
31 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review