Review on 🖨️ Eryone Filament 1 75mm: Next-Level Additive Manufacturing Products for Top-Notch 3D Printing by Ronald Bleimeyer

Opened the package, inserted the spool, cut off the winding part of the filament attached to the spool tab, inserted the cut end into the printer, and started printing. Worked in the yard for a while more. After 2 hours, 30ft of filament is on the ground and the print failed. The spool they gave me had a wrong end. As it was pulled into the printer, the spool rotated and the actual end detached from the spool and began to unravel. Once the free piece of filament wound on the spool ran out, the print would fail and the real filament would unwind on the floor. then ejects a huge amount of filament - the prints are terrible. This happened regularly everywhere. A very thin section appears every 5-10 minutes, followed by an over-extruded section. Sometimes the extruder gear will click several times before the jam comes out. DO NOT BUY