Review on 🚗 QKPARTS Hoypeyfiy Center Console Cover: Gray for Toyota Highlander 2008-2013 by Victor Anderson

Pros: 1. Looks like factory but better. I assure you that if everything had been done correctly, no one would have suspected that it was not factory! I replaced the braces (I recommend that because that's how it works) and used the 1/4 variant. It's not exactly short, but it works. Otherwise, you will spend a lot of money on the main material, which will make the company more expensive. If I bought the same staples, it would be less to buy ready-made ones. I used a variety that has a sharp stainless steel tip. looks perfect On the other hand, there were no brackets sticking out, which I think was my biggest problem with the install. I have a silver mountaineer with black floor mats, I want to change the color from silver to black. If I had another one it would look great. Only later did I realize that. Disadvantages: 1. There is a crease in the middle, which forms a line on the material to be shipped. I think they should switch shipping to flat design with no creases. This line is difficult to remove and will disappear after a few weeks. If I look very closely I think I can see where it is, but it's basically invisible. I'm very picky so I can assure you it won't break the deal. I almost gave it 4 stars but the stitching/finish quality is so high that I don't think it's fair to rate less. If the carrier had made just one change, it would have sold more and likely earned a consistent five star rating. To minimize the effects of folding, I stretched while stitching and heated with a hair dryer throughout the process. I also used hair dye on the crease and tried rubbing it off. He eventually disappeared to the point where he could no longer be seen, unaware that he had been there very vigilantly for a long time. I will never see him again. Be careful as you sew so you don't break the small plastic tabs. I broke one, not realizing that aligning the lid was important. By making a few cuts in the material, you can stretch it better. So I would recommend. To start, use a butter knife to rip it open - this works best. The rest is pretty much self-explanatory as you can reverse engineer easily.