Review on 👜 Vegan Leather Men's Wallets with Advanced Blocking Technology - Essential Men's Accessories for Wallets, Card Cases & Money Organizers by Dewitt Graham

This is an unbiased, unbiased review. I bought this wallet because of the set up myself, fold out license holder on the left side with 3 card slots on the back. Also double, not triple. Also, it looks very neat with the carbon fiber fairing. They also claim to have RFID blocking, which is handy for walking around places like Las Vegas. I have not tested the RFID capabilities. It's also marketed as an eco-friendly faux leather wallet, but that didn't change my purchasing decision, I'd be just as happy with real leather. The inside of the wallet even says "vegan leather" but oh well. Pros 1) The appearance of the wallet. This is important to me because I'm used to the slots for each card or item. I didn't want to come up with new storage locations and I had a hard time finding an RFID wallet with the layout I needed. 2) The carbon fiber exterior is really impressive, apart from the "vegan leather" embossing on the inside3. ) Doesn't smell. Faux leather can smell awful, but this one doesn't. Cons 1) First, there was a plastic bill separator in the bill compartment. I hate it in the sense that I'll never be rich enough to share my money. As you can see in the picture it was relatively easy to cut out the divider with a utility knife without damaging the wallet. This is only a scam if you don't need a bill separator. 2) The nine card slots are inverted leather and bound only on the sides. As you can see in the photo, the valves come out easily. In most slots I keep credit card sized things sticking out slightly so I don't open the slots with my fingers so I don't notice. However, I have two small key cards that I have to put my fingers through the slot to get them out. A week later, the valves on these grooves were damaged beyond repair and are now sticking out on their own. To fix this I glued all the valves to the bottom and there have been no problems since. I feel like they should have held the valves together with glue or sewing at the factory. Overall I like that I cut out the bill separator and secured the card slot flaps.