Review on OMOTON Screen Protector IPad Pro Tablet Accessories by Seth Heck

Everything works with this screen protector. I have an iPad Pro 2nd Gen 11 inch 2020 with a 2nd Gen Pencil. Touch sensitivity, face recognition, pencil, everything works without lag or lag. I assume that due to mass production, some people will not have the same experience as me, so some people may receive defective products. It also fits perfectly in my ESR pen holder case with no rise on the edges. It took me a good half hour to put it on just to make sure there was absolutely no dust on it and that it would fit my case perfectly (I used to put screen protectors on and learned the hard way that I don't have patience ). I held it up to the light, looking at every possible angle and did this in a windless bathroom before removing the background. After I applied the protective film using the guide stickers, it stuck perfectly and without any defects, except for two dust particles that I easily removed. The only thing I didn't really notice was the fabric, as it creates dust if you're not careful. The more you use it, the more dust it produces. I suspect it's because the edges of the fabric fray a little when rubbed. But the dust sticker is life saving and much easier to use than sticky tape as it is very flexible and thin rather than rigid. Just make sure the sticky material from the edge of the sticker doesn't stick to the glass. But even if it does, you can still use the sticker to remove it. Just put it on the screen. Otherwise, it's the perfect screen protector. I don't know durability. I only bought this as extra protection but hopefully I won't drop my iPad to see if it works.