I usually mount computer fans directly to the case. My new build was very quiet, but I could notice that some vibration noise was transmitted to the computer case and the case acted like a sound box. I had never tried these rubber isolators before and decided to give it a try. Remember that there are 2 different rooms. A thinner gap is installed on the case side and a thicker gap is installed on the fan side. When installing, install on the fan first as it takes quite a bit of force to pull them through the screw hole. You'll feel like you're about to break the small pieces, but just keep pulling and they'll eventually pop out. After that, line up the holes in the case and pull through. The difference in sound is simply amazing. I am very happy with the purchase and will be using them in all my future builds.
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
🔩 RION TECH 4 Pack Rubber Case Feet + Set of 10pcs Repair Replacement Screw + 1pcs 5 Point Pentalobe Screwdriver for MacBook Pro Retina A1425 A1502 A1398 13-inch 15-inch Bottom Case (Retina)
10 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
Neural Compute Stick 2 by Intel
12 Review
Enhance Your Development Projects with the NVIDIA Jetson Nano Developer Kit (945-13450-0000-100)
12 Review
🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review
DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory
9 Review