Review on Enhance Efficiency with Sealer Replacement Element for Impulse Sealers in Hydraulics, Pneumatics & Plumbing - Seals & O-Rings by Jessie Ritchie
Doesn't fit right. Jump out now!
The heating element barely stretches to fit a screw but immediately pops out of the back because it's too short (less than 1/8 inch - so annoying. I cut myself and am 100% upset and disappointed I urge you not to buy from this company This is a basic 8" impulse sealer How difficult is it to get the correct measurements?
- Kitchen & Dining
- Damaged
New products
Comments (0)
Top products in π οΈ Seals & O-Rings
Another interesting products
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review