Review on 🔑 Keyless Entry Car Key Fob Remote Replacement for KBRASTU15 CWTWB1U758 CWTWB1U821 by Marcos Olvera

The remote control is good as a trader. Works perfectly and programming is very easy. There were no instructions but I stumbled upon the steps from one of the posted reviews. Setting mode: 1. Close and lock all doors. 2. Insert and remove the key from the ignition switch more than 6 times within 10 seconds (the alarm lamp flashes twice). At this point, the original ID codes will be erased. Entering the ID code: 3. Turn the ignition key to "ACC" 4. Press the "Lock" button on the new remote control once (for example, if the door is locked with the remote control in this ID code input state, you can enter a new ID code). At this point a new identification code will be entered (the alarm lamp will then flash twice). To enter an additional ID code: 5. If you need to activate additional remote controls, unlock and then lock the driver's door again (USING THE DOOR LOCK SWITCH). 6. Press the lock button on the optional remote control once. .7. This ID code activation state and setting mode will remain until the driver's door is opened. NOTE!* If you need to activate more than two additional keyless remotes, repeat the procedure to enter an additional ID code for each new remote.* If the same ID code that is already in memory is entered, the hazard warning lights will flash twice , but the entry will be ignored.* A maximum of four ID codes are allowed and any attempt to enter more will be ignored.*Any ID codes entered after exiting setup mode will not be accepted. Additional keyless fob signals will be disabled unless the ID code has been entered in setup mode.