Review on JAREES Filament Surface 🖨️ Printer: Accurate Printing with ±0.02mm Precision by Bret Wong

Prints have been perfect so far. The size of Makerbot's internal filament holder is specific to Makerbot and they want you to buy their filament at 2x or 3x the price for half the product. I have a filament spool setup on the side of a Makerbot on a spinning lazy susan. I attached a spool of filament to Lazy Susan (mine is metal) with magnets and it works perfectly. I entered GROOT Head, 4 hours and no problem. I use the included JAREES print sheet attached to a glass bed covered with blue 3M painters tape. and prints are easy to remove. I tried using Include Sheet alone, but Print almost became part of the sheet. Luckily I only opened the 20cm box to try it out. Overall the thread worked and I will be buying more in different colors. Printing temperature 215C. GROOT Waving stopped printing when the filament was snaking in front of the feed tube (not a JAREES issue). As you can see, My Print Bed is very large. It would be great if JAREES could send a larger spread, but then the box would be too big lol. Finally, printing on printable JAREES sheet at 215°C caused the sheet to heat up and start to deform and melt into a print, great adhesion, it was almost impossible to get a print