Threaded part too short on male end. For 1/4" NPT, the threads should mesh 3/8" and the distance from the shoulder to the end of the last thread is shorter. It will be difficult to seal properly unless a curing thread sealant is used. I changed the rating to 1 star because the low thread issue makes it useless or at least very bad in most cases.
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
Vacuum cleaner Dreame V9 Global, white
145 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review