Review on One Cord Channel Cable Concealer Management by Duane Kaul

I wanted a single cable solution that was not a D-shape and that would be perfect for my needs. I used them in a guest room where I was hanging a few lamps and dangling cords needed a tidy solution. The glue comes on a roll that is separate from the channel which allowed me to use less of it and put it where it was. necessary. The upside was that I could only fit a couple of inches at each end of the canal. This allowed me to easily attach the duct to the wall and then gently pry it off (wiggle it a bit) if I needed to move the duct. Once installed it was easy to press firmly against the wall to secure it. I started placing a duct at the top of the wall (about 1/2 inch down) for my setup. I left about 1/2 inch between each piece of duct as I attached it to the wall to allow room for the carpenters. I found it easier to place the woodwork on the bottom piece (the outer part of the channel), then attach it at an angle to the next piece and slowly snap it into place. I'm attaching before and after photos as well as the connection process in hopes it will help someone else. Great product, it's perfect for my needs!