Mine looked fine with finished surfaces as in the picture but the exterior carving is huge. This means if you have a blind hole and can't run the faucet very deep, you won't even be able to fit the faucet in the hole. I sharpened and rethreaded my cheap tap a few 1/16 at a time, but only gotten a half turn. It would be nice if they were available with a reduced external thread diameter for blind holes. The only option would be to reduce the threads on a CNC lathe to preserve the taper. Too bad I didn't cut a straight threaded hole at this point.
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review