Review on 🖨️ CUBICON ABS Filament - Advanced 3D Printer Filament for Optimum Performance by Mario Beaklini

I have several others tried "abs" threads. Hatchbox and Domestic, and manufacturers continue to tinker with fillers and additives that supposedly make the press easier to print, and as a result, the press doesn't behave like a press. This thread prints like a press. Bed set to 110, hotend to 250 for 1st layer 245 after that Fan low for overhangs and bridges and off for easier details There is no warping near the bed, bridges and overhangs print well and cleanly The base case only has the sides and the top open so hot air is obviously escaping but other than that the envelope is around 45C Fan adjustment to find the right combination for clean slopes and reduced kinking Weni ger fan, prevent large parts from deforming. Small details are no problem. My only complaint is that the red on the reel comes out very muted and not bright red. The rest of the print is very clean.