Review on 🖨️ High Precision LCD UV Curing Photopolymer Resin for WEISTEK 3D Printer - Ideal for SLA 3D Printing at 405Nm by Ron Houston

Only ordered on recommendation from a friend. I usually use Elegoo and get great results, but it's a bit cheaper and I wanted to reassure this friend. I can only say wow! It has practically no smell, the resin flowed into the tub very gently and the quality of the finished first prints was amazing! I can't tell any difference between this material and the Elegoo I used, except that the smell was even less. The first time I waited for the imprint to be high enough to see through was when I was biting my nails. But when I saw five sets of coasters happily attached to the stove, I was relieved. Detached from the plate, the coasters were very light and after a quick wash they almost couldn't be bothered anymore. Great experience. I print on an Elegoo Saturn and just use the same resin profile I use for their standard gray resin. I think I'm overcooking the bottom layer a bit, but all the layers above are somewhere in the 3-5 second range. To be honest I can't remember because I don't change my profile settings often. I am already ordering another bottle and may try my first bottle clear!