This is a great Arduino RF sensor station. Using the RadioHead "RH_RF95.h" library. I have several, send data, fall asleep, resend data, sleep. If you are receiving an HF on a different type of card you will need to ensure your data structure is the same size in bytes as not all MCUs are the same. I've found using "short" to be the most compatible. I used the "Adafruit Feather 32u4" board in the adruino IDE. The pinout corresponds to pin 32u42. The sleep current is 0.13mA using the "LowPower.h" library which also has a sleep interrupt to wake up.3. The activation pin comes in handy when you don't want to use the voltage sensor to turn off the ESC when the battery is low.4. It has a solder bridge to increase the charging current to 500mA. I have a 5V solar panel connected to a 5V pin with a large capacitance of 4700uF. Uses a standard 2mm JST LiPo battery connector and perfectly charges the battery. The battery connector is at the top for easy access.6. You can hibernate it at any time by calling a for loop. int i; for (i = 0; i < sleepCycles; i++) {LowPower.powerDown(SLEEP_8S, ADC_OFF, BOD_OFF);}7. Has a built in battery voltage divider to read the battery voltage across terminal A9.8. The adjustable antenna is good9. Suitable for a breadboard with an extra row of pins on each side. If you only need it as a HF station to send data, no OLED or WiFi, this board is much better than the Heltec WiFi Lora esp32 kit board which I am replacing with this LoRa32u4 board. The only problem with all 32u4 microcontrollers is the serial monitor and uploading the sketch is a bit of a hassle until you figure it out. You need to press the reset button after the download has started. I wish it had an SMA connector for the antenna.
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review