Review on π Solid Brass Heavy-Duty Valve Switch by Joshua Castillo
Thread depth in ball valves
I installed these valves on the duct. I couldn't get her to stop licking, even with pipe lube and teflon tape. It turns out that the thread does not go deep enough into the valve. If you tighten the pipe it will go down and no tightening will stop the leak. I ended up cutting an eighth of an inch off the pipe to stop it from flowing.
- valves
- Big and bulky
New products
Comments (0)
Top products in π§ Fittings
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
