Header banner
Revain logoHome Page
Vanchay Sangkeaw Ice ᠌ photo
1 Level
106 Review
77 Karma

Review on Enhanced Black Water Cooling System for Alphacool Eisbaer CPU 420 CPU by Vanchay Sangkeaw Ice ᠌

Revainrating 2 out of 5

The purchase did not justify itself at all.

Stands in a be quiet! Silent Base 801 Silver on the front. Blow inside. I bought for the processor 8700k. But now it costs 6400. Acceleration to 4200 voltage 1.310 - 1.315 In idle temperature 38-40, in the room 25-27. The pump always runs at 100% but the fans at 15%. Under load, the Aida stress test heats up to 54, with a temporary jump to 57 for a couple of seconds. In games 50-55. Jumps are up to 62-64 for seconds. Jumps because the regulation of the fans is not constant. Up to 50 degrees by 30%, and by 60 already up to 90%. Grizzly used the paste. The pump is not heard. Fans of course are closer to 100% noisy (the air is noisy). 3 weeks later I bought a new proc. Not quite what I wrote here earlier. Took 9900kf. . Proc without overclocking. I overclocked the current RAM 2 bars of 16 Samsung 2400 in overclocking to 3400 (19/20/20 1.35) Fans for blowing in front of the case. When the desktop in the BIOS is set at less than 40 degrees, the speed is 15% = does not spin at all. Silence. There is also a reserve for overclocking, but it takes a whole day to select the maximum frequency and voltage plus tests. So far it's good that the desktop is 35-37 In this case, the turntables = 0 speed. In the load on one or two cores, the temperature is 45-51 turntables by 30%. Hades test 75-81 turntables at 100%. In games 55-65, depending on how many cores it loads, the turntables are 70%, All fans are manually adjusted from the mother (8 4-pins in it) ate after two months.) The motor at the pump is noisy. Noise is not as strong as that of the corsairs or bi-quiet. It's the same motor. And it only makes noise when installed. When I take off I put it for 3 hours, there is just no noise on the floor. The Germans, of course, have sent me a new one from Germany. But as I read the forums, the design here is bad. There will always be noise. I lost juice current on one thermal paste while I was looking for how to remove the noise. I also bought a second radiator, as there was advice to increase the volume of water or place it on top. I DO NOT RECOMMEND to buy. At the moment, I now just have a custom CBO.

Pros
  • Dimensions (thickness 3cm). Set. Price (for 11300 took). Possibility of adding more to the circuit in the future. Filling or topping up liquid. Transparent glass (you can see the liquid level and pump operation) Removable hoses. Copper radiator.
Cons
  • Complete 140s from the BiQuee are noisy at top speed. A month later he added a new minus, the pump is also noisy. But what is interesting is that it does not make noise immediately at the start, but hours later. The shaft itself that drives the liquid is noisy. Such a crackling sound. Short hoses. Since they are short, with a strong bend, the hose may end.