Review on Efficient Crimping Made Easy: TICONN Heat Shrink Connector Crimping Tool by Leonard Herrera
Does not have any other instructions, difficult to adjust
No instructions other then what is in above ad. This tool is not easy to adjust. You unscrew the screw near the star adjustment wheel and have to open and close the crimper to adjust. But how far to adjust is anyones guess. One setting literally crushes the terminal flat. One setting leaves a small gap and one setting leaves a bigger gap. Overall not easy to see or tell which setting is too much or too little other than pulling on the wire after crimping. If the wire comes out it wasn’t enough and you just wasted a terminal.
- Simple setup
- No-cut insulation feature leaves insulation frayed
New products
Comments (0)
Top products in 🔌 Electrical Tools & Hardware
3-Pack FOSHIO Utility Knife Retractable With 30 Degree Snap Off Blade For Vinyl, Paper & Craft Cutting
39 Review
Complete 220-Piece Pink Tool Set For Women – Ideal For All Home Repairs And DIY Projects
41 Review
🔧 Eastvolt 218-Piece Household Tool Kit: Complete Auto Repair Set for Homeowners - Hammer, Pliers, Screwdrivers, Sockets, and Storage Case
34 Review
DEKO 196-Piece General Household Hand Tool Kit - Includes Rip Claw Hammer, Lineman'S Pliers, Measuring Tape, And Plastic Toolbox Storage Case
32 Review
Another interesting products
💡 Electronic FL Ballast ICN-4P32-N (Formerly ICN-4P32-SC) for 3-4 F32T8 F40T8 F17T8 Lamps, 120V/277V Compatibility
5 Review
Wireless Electronic Ballast Interface Certified
8 Review
🔌 Robertson 2P20132 Quik-Pak: 10 Fluorescent eBallasts for 2 F40T12 Linear Lamps, Preheat Rapid Start, 120Vac, 50-60Hz, Normal Ballast Factor, NPF, Model RSW234T12120 /A (Crosses to RSW240T12120 /B)
4 Review
Fulham WorkHorse WH2-120-C Adaptable Ballast - 2 Pack
3 Review