Review on Wi-Fi router ASUS RT-AC66U, black by Eh Shee Lay ᠌

I'm trying to persuade him to work for the third day. Connected to Beeline. I have 3 laptops, a tablet and five other devices. I bought it to replace dir-320. Dlink plowed for almost two years, but the tariffs changed and it began to cut speed. I chose it according to the reviews, launched it, flashed it for the latest firmware 3.0.0.4.270. I connected to the Internet without any problems, at first I didn’t tinker deeply in the settings, and when testing the wafer, I didn’t give out more than 3 Mbit per download. I had to climb into the professional mode and randomly select incomprehensible parameters, it is not clear what they are measured in . in general, I squeezed out 15 Mbps in both directions. On the second day, it did not allow me to connect to the web muzzle, the average time of opening a web muzzle page was about three minutes, by the evening it began to open normally. But some of the sites do not open, this part is about 70% and you should not think that something is configured incorrectly in the system, there were no such problems on dlink, and you cling to the mobile whistle, everything opens normally. I also noticed that the ping is walking up to 1500 ms ! Therefore, sometimes he thinks for a very long time before opening the pages. I picked up an HP LJ 1022 printer, set it up for 3 hours, it still printed, but after sending it to print and printing it takes up to 10 minutes and this is plain text ! All this happens both on the wafer and when connected with a wire ! I repeat, there were no such problems on dlink at all! Printed instantly, opened pages in years! The torrent starts up for a very long time, but when downloading, it gives out almost the maximum speed according to the tariff. The device is good, but the software is terrible! I will try alternative firmware! I don’t advise for beginners, I can’t return it, they brought it from another city. If I had known, I would have bought keenetic giga! A friend has one, no problem. I installed the firmware from Merlin 3.0.0.4.270.25, the gigabit network and n wafer work without problems, with the g wafer there are problems - the speed is not more than 1Mbps, and for 100 Mbps LAN the speed is more than 3 Mbps, the printer could not be persuaded to work! I have a great desire to spit in the face of the developers of this miracle.