Review on Protect Your VW Atlas with TOPGRIL's Mud Flaps Kit - Front and Rear Mud Splash Guard Set for 2018-2020 Volkswagen Atlas by Bob Larson

Front fitment was easy, rotate tire direction to make room for tools, wheel arch liner on 2019 VW Atlas is plastic. On the front Use the OEM screw at the bottom of the hole first, then drill a tiny pilot hole with a 1/16 bit bit at the edge of the 2-hole pad, avoid deep drilling. No metal to drill. You can reuse the factory screws. I have side steps so the front bottom screw was a bit difficult to drill through. Use the puck. Install the screws by hand to avoid cleaning the holes. You will need a Torx T25 screwdriver and a Phillips screwdriver. In the back I didn't remove the tire, didn't have to use a long drill extension and go around the tire. On the back I started by using 2 existing screws, drilled a 1/16 into the top valve hole and attached to the edge of the fairing. On the back bottom, remove the bottom screw holding the stock fairing. It was too short to be reused. I used a 1 1/4 stainless steel washer and screw from my collection to secure the bottom of the valve. Don't forget to use your flashlight to manually locate the downhole drive. Again, save any screws you will need. HAND TIGHTEN ALL BOLTS IT IS ALL PLASTIC AND WILL STRIP.