Review on HOOBRO Side Table: 2-Tier Nightstand with Drawer for Small Spaces - Stable and Sturdy Wood Look Accent Furniture with Metal Frame - Greige and Black BG04BZ01 by Etai Gopala

I received this table today. Assembly took about 20 minutes. It was well packaged, all parts intact, not a single scratch on the very solid wooden boards. All ends and sides are sealed so you can use the boards in any direction and align all screw holes. Very good stable table that is worth the money. It fits perfectly next to the reclining backrest and since the drawer opens at the end, it makes an excellent reclining side table. After returning many tables over the past few weeks, I've become a pro at furniture assembly. However, a few things I would change or point out in the instructions would be: * Don't do step 1 until after you've gotten through step 2. You can more easily attach the lower leg to part 3 if you don't have a top. vicinity. Just make sure that when you place the bottom of the leg on part 3, the opening of the top of the leg faces inwards. After putting on the lower parts of the legs, lift them up and put on the parts in step 1. * In step 3, when inserting the screws into part E, do not tighten them until they are just inserted. Do the bottom screw first. If you tighten it before inserting the top screw, the holes will not line up. * Also in Step 3: Parts 4 and 5 will be inserted INSIDE the arms where you will bolt them. Do not overtighten or you may dent the metal legs. Part 7 is connected to the end without part E. Make sure part 7 is on the opposite end. Again it goes INSIDE the metal leg. Don't tighten the screws until all 4 are in so you can pry them out a bit to make sure the screws go into the pre-drilled holes. (8) but it is not. It just passes. Make sure the small edges are facing down towards part 6, this is the stopper for your drawer. Place the wooden board (8) with the narrow side towards part 6 and the wide side up. This is a drawer slide. * At step 6: when you turn over board 6 it doesn't show you which side piece 8 should be on it Make sure piece 8 is on the end that has the clips of piece E as that is for pulling out the drawer. Turn the table upside down to tighten the screws B to make it easier. At this point you can tighten any screws you've made so far if you haven't already. * Step 7 starts the drawer. Make sure you have a drilled slot at the bottom of all the boards when you put them together, that's where the bottom of the box slides in. Do not insert locks C into boards 10 and 11 until you reach step 9. *In Step 9: Make the locks C by holding the pieces together with part 13 (bottom of box first). Once fasteners C are tightened, this makes it easier to assemble and screw in item 12. Item 12 is included INSIDE the side panels. Boards. My side screws were loosened, the middle one is well tightened, it still works fine. Make sure the little tabs are on top of the drawer like in the picture because that will go onto part 8 that you put together earlier to slide the drawer in and out. * If you need to take out the drawer after installation, just grab the plastic part you made next to the wooden board and twist it, and then the drawer can be pulled out completely, otherwise it's a stopper to prevent it falls out You're done, make sure to tighten everything.