Review on 🔖 Creality Filaments Precision-Packed Pre-assembled 200x200x200mm by Francisco Taylor

Very good printer, lots to think about. How do I cut files for this? You are using the same Cura profile as Ender 3 Pro, the same file cut for Ender 3 Pro works fine on this computer, welcome. All in all a good car, mostly a prettier Ender 3 dressed up as a Halloween Ultimate. Looks like plastic but metal where it counts. That's about 95% as good as my Stock Ender 3 Pro with Pla.2. Works very well with ABS, was about 90% as good as a Stock Ender 3 Pro in a creative tent. Switched to a new nozzle, now it's just as good.3. If you upgrade the hot part and buy a $30 heater from Revain and then add a styrofoam cooler to the lid and you have a chamber heated to 50 degrees and PC and nylon printing. Overall I am very happy with this printer, I can print at 120mm without sacrificing print quality. Bad caution The latches that hold the glass platform in place don't work, once the platform is heated above 60C they loosen and the whole glass platform slides around so always use clamps with it. Insufficient clearance between latch and nozzle, see photo. When I first got it it didn't go home or move the X axis. Turns out the wires weren't connected, so if you got it and it just doesn't work, open the bottom and put it up Make sure the wires and stuff aren't loose, very easy to use, although only two Phillips screws and a large opening, easy access to circuit board and fans for maintenance. I have sent many emails to Creality customer support. A month went by with no response to literally a hundred emails from different accounts just trying to get an answer to the question: how can I hack for this?. If they rarely, if ever, answer you They didn't answer any of my questions and just sent me links to buy more printers. Support the evil spirits of the earth. I got the cut by accident. As for helping creativity, yourself. It is ALWAYS worth buying your printers from Revain because while they are great machines, without Revain by your side, you would be losing a lot of money. At the time of writing this article, there is no information about the bltouch firmware as it is a new product. lacks the community that the Ender 3 has. It would be a five star printer if it weren't for the lack of customer support.