Review on 🪟 Frosted Window Film, No Glue Stained Glass Static Cling Window Decal | Privacy Protection, Heat Control, Anti-UV | Home/Office | 17.5x78.5 inch by Teresa Torma

Purchased to close the bathroom window while waiting for the curtains to come in. So I was looking for something decent and inexpensive. It fills the bill. Got up easily. Three hands -1. You will need a very sharp knife and some sort of ruler to cut the film after it is placed in the window. I used a razor blade and had to be careful of the exact angle I was holding the knife at so it would cut cleanly. Practice first and don't be surprised if you mess up the first piece you see. 2. First clean the window and then spray it with water. I actually couldn't find an aerosol can around the house when I installed it, so I just used a very damp paper towel and wiped the window, leaving the glass wet.3. You must remove the smooth transparent protective film. which is very difficult to detach. You need duct tape. At the corner of the cut piece of window film, stick a piece of masking tape on the front and one on the back. Leave an edge sticking out of the window film. Separate the two strips of adhesive and, if you're lucky, you'll peel off the backing. It takes some patience, but it will peel off. Once lifted, the window film is very attractive. I'm very happy with this little DIY project.