I installed two of them for water filters. One of them works fine. The other, however, flows through the copper wall! I don't know how that's even possible. To be clear, the leak appears to be at or at no connection point. It flows through the brass wall. It's a slow leak, but a leak nonetheless. Another commenter had the exact same problem. Now I have to buy another one and solder everything and this is a nightmare due to an obvious manufacturing defect. I was a huge Shark Bites fan, but that's hard to forgive.
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
Flexaust 611S Polystyrene Cleaning Crevice: Versatile and Efficient Solution for Deep Cleaning
4 Review
Guardair 79SG012 Syphon Spray Gun
3 Review
Ultimate Performance: SpringSpray Aluminum Equipment Heavy Duty Industrial for Optimum Productivity
3 Review
π§ Thermoplastic Aluminum Fitting Equipment by SAFBY
3 Review