Review on 📺 Mount-It! Long Extension Dual Arm Full Motion TV Mount Bracket with 36 inch Extended Articulating Arm, Compatible with Screen Sizes 50-90 Inch, VESA 800x400mm, Supports up to 176 lb by David Estevez

I am not satisfied with this product because the drywall anchors that came with it are of poor quality. I managed to screw it to two studs (one in the middle of the wall mount and one on the left side. I chose to use the two drywall anchors that came with it to give the right side some strength. As you can see on the As can be seen in the pictures, there is a thin gap inside the drywall anchor that should disengage when you drive a bolt in. The problem is that once the bolt enters this slot, the anchor rotates and the rim that the Anchor holding to the front of the drywall, breaks off...damages the drywall a bit.I should have stopped after the first one broke but I thought it was an accident and I felt a fixing point is better than none, so I tried the next one, and "BAM!" Same thing. The screw got stuck and I had to damage the drywall to get it out. Use k a drywall anchor for no reason. They are absolute rubbish. Also, none of the thousands of screws the products that come with this thing will fit any TV or monitor I have. Even if they were, they're too long, so you still can't tighten the VESA mount screen without installing a screw about a quarter inch in the monitor. Also, the handle that allows you to tilt the monitor down faces forward by default. At the very back of the screen. After a lot of cussing and a trip to the Home Depot to get the screws needed to mount the monitor, I finally wall mounted everything and everything is working fine so far. This was the most uncomfortable wall mount I have ever installed and I will not be buying another from this company. I like how far the crowbar moves from the wall, but it's not worth the damage and frustration.