
I like that no screws are required for assembly. RP3 just snaps into place. Absolutely not brittle plastic. Very difficult. I think it's better if the antenna is at the end and under the RP3 board, but there are plenty of holes to knock it out on the sides or at the end above the board. I attached mine to the battery with velcro and made a micro USB cable and switch with 90 degree connectors to make everything a bit more compact.

🔍 MANN-FILTER W 811/80: The Optimal Oil Filter for Enhanced Engine Performance
11 Review

🛩️ Stratux ADS-B Dual Band Receiver: Advanced Aviation Weather and Traffic System with WAAS GPS, AHRS, Battery Pack, Suction Mount, Antennas, SDR
9 Review

✈️ Enhancing Aviation Safety: ASA-OVC View Limiting Device for Clearer Vision in Overcast Conditions
9 Review

🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review

70mai Dash Cam Lite: Full HD 1080P, Smart Car Camera 🚗 with Sony IMX307, G-Sensor, Wide Angle FOV, Night Vision & Loop Recording
52 Review

70mai dash cam midrive D01, black
53 Review

DVR 70mai Dash Cam Pro Plus Rear Cam Set A500S-1, 2 cameras, GPS, GLONASS, black
44 Review

Upgrade Your Car'S Safety With CHORTAU'S 2023 Dash Cam - 1080P FHD, 170° Wide Angle, Night Vision, And More
44 Review