Review on 🔥 Premium Jetson Nano Case with PWM Large Cooling Fan - Compatible with B01 and A02 Versions - Boosted Cooling Performance - By iUniker by Jeremy Monroe

. I like the compact profile of this case but it doesn't fit on Nano B01 board or NX board as power and reset pins are on the edge of the board horizontally under the Nano/NX- Module so you don't have room to plug in the power/reset buttons. The solution is simple: use four jumpers connecting power/ground, power/power respectively. , Reset/GND, Reset/RST, four pins on the board, then use extension wires to connect four wires separate from the power/reset buttons. Just be sure to properly identify RED (power or reset wire) and black (GND). Also, don't forget to use the fifth jumper to connect the Auto Power/Disable pins. Overall I like this case, I just hope they can make another compact case specifically for the Nano B01 and NX boards. new Xavier NX Dev Board into the case, I had to remove the bezel along which the M.2 WiFi module is attached. Once the panel is removed it is not much different from the Nano B01 carrier board and then you can use the setup above to fit it into the case.