Review on Filter under the sink Geyser Prestige 2 (12 l) by Stanisaw Muter ᠌

I bought it primarily for an ultrasonic humidifier. Before that, I drove water through Aquaphor Modern (2 cartridges) - zero sense, the whole apartment is covered in white, now we don’t know how to wash it. Therefore, we decided that we needed a reverse osmosis filter. Friends of this type have it and the ultraviolet humidifier does not leave any plaque. I took a 12l tank, and this is quite enough for a humidifier (6l tank) and everything else. In this tank of finished water, about 7 liters are obtained! Delivered only yesterday, so not yet a complete set of impressions. It is very easy to install. Honestly, I didn’t understand these squeals on the network about “everything flows, why the FUM roll was not put in the kit”, etc. There is only one connection on the tank, which requires a couple of turns of FUM tape and that's it. 2 connections that you just need to tighten tightly, well, a tie-in, there are also gaskets and no FUM is needed. The tubes are coolly made - stuck it in and that's it, the child can do it. I specially took the simplest three-stage option, because I still don’t understand why some more pre-filters and post-filters are needed, if osmosis purifies water almost to molecules. If there was a filter with one osmosis and a tank. then he would have withered him. It is recommended to drain the water at the beginning not into the tank, but directly from the blue tube into some container until the black (coal) water stops flowing. But I didn’t have anything black in the water, clear water immediately flowed. It is a pity that the manufacturer does not make collapsible steel tanks. I don’t think it’s very difficult to do, but you’ll have to be nervous about imagining mold inside. A new tank costs 2500r. Nafig he is not needed. There are options with a transparent sort of like a collapsible tank, but the seller said that they did not take such for sale because there were a lot of customer complaints about them. By the way, the tank is just a storage tank, there are no filters or membranes inside. So theoretically it can eventually be replaced with any tank capable of holding such pressure. Maybe later I will put something of my own, for example, a tank from a spray pump. It can be taken apart and washed.