There should be an instruction on how to change out the choke shaft. Although it comes with 3 different set ups, I can see how the do it yourselfer may have trouble discov

Just the right part, it took a while to start even after running gas and I know the carburetor was full, but after few cord pulls engine started and works fine, I waited few hours and starts on the first try.Somehow this carburetor works different from the original one, the original use to start on choke and had to keep the choke closed for a minute or two before set to run, this carburetor you need to crank on choke and it wont start on the first one, then you move it to run and it goes, for…

Not sure about the durability but after install my generator fired right up and idled great no adjustments necessary Thanks for attention.

I have a Briggs & Stratton 5500W portable generator (engine number 21T2020121G1, carburetor 796321). The carburetor was leaking gas very badly, and it had leaked into the crankcase, which contained more gas than oil. Since I did not know specifically what was wrong with the old carburetor, rather than mess with trying to rebuild the carburetor, I bought this replacement. It was pretty easy to install. I also bought the E5 Torx bit, but a regular 4mm Hex bit would probably work. After replacing…

Worked fine on my Briggs and Stratton Storm Responder Generator. It comes with many carb pieces such as the choke levers. Note I had to remove the butterfly plate by pulling the plate out. Then I could pull the plastic piece straight up and replace it with the one the same as the original one. I also had to drill out the plastic bushing on the carburetor so the choke rod (included would fit). Also had to pop off the plastic piece that clips back on the choke rod. Also allowed for putting the…

I have a Briggs & Stratton 5500W generation that would start up but then dies after a few seconds. I did some research and checked, but my unit did not have any low oil sensor, so that wasn't the case. I found that I could manually fiddle with the rear choke back and forth repeatedly and quickly and keep it going but it didn't run very good. That lead me to believe it was the carb. I watched some youtube videos on how to clean the carb and the jets. Looking on Walmart for gaskets I came across…

Easy to install ,all the parts were there.Installed on a generator and it started right up. As far as how long it will last is to be seen.

What a great product! It came with everything you would need to replace the existing carb. My generator only had less than 24 hrs on it but it wouldn't start. Tried cleaning carb to no avail. As others said this bolted right on and started right away. Perfect! I am only rating this four stars as it would have been nice to have instructions. This replacement carb fits a Nikki 697798 although it is not listed.