948004 Bearing Race Seal Ins Review

The tool did the job but the soft aluminum has been damaged with proper use. I would not recommend it for very heavy applications. I used it to install a front and rear sprocket on a Ford 7.5 and the rear one damaged the tool. It's enough for one-time use, but don't expect it to last long.

Beautiful set. But there is no size for GM 10 wheel bearings. You can change the diameter of the one that is too big by about 0.050 inch. Save the old bearing's outer race to whack it with. Pros should buy a kit with many other sizes. Aluminum driver.

Loved that they match my ez loader boat trailer. I was paranoid about getting a set that didn't match the race. The only complaint is that the nut won't tighten on the smaller race settings. Other people have commented that these aren't the best tool for everyday use, and I agree that they're aluminum and you'd want to rip them apart instead of your race. I recommend this product

Worked great removing and installing the power steering pump pulley on a 2003 Chevy Monte Carlo 3.4. It would be nice to have a guide for this, but in the end I was able to figure out how to use it. It worked great and got me moving again. I don't think I could have done it without this special tool. Some of the tools are only for non-GM applications and I've had no reason to use those parts, but they all look well made.

I used this screwdriver set to install bearings and seals in a 2001 Chevy 7.625 inch ring gear differential. The drivers didn't fit perfectly, I understand there are thousands of different sizes of bearings. I gave it 5 stars because it's an inexpensive bearing and seal driver. I used the old race and the back of the disc for two races because it didn't fit. It fits some camps, not others. I don't know if it will hold up to the store, but for casual use it's probably good enough. I'm glad I…

Works Installing the power steering pulley was excruciating as the bolt kept coming out of the pump shaft. I used an impact wrench more than 10 times to carefully reinsert the bolt. There must be a better way to reattach the pulley. When tightening a bushing on a bolt, the bolt comes out in just a few turns. Allow 45 minutes to put the roller back on and very good attitude. I wish I had a better product to share with you but it really worked, I'm glad it's over. I have a 2000 GMC Sierra Z71…

The important thing is how you remove the bearing. You must pay attention. Once you have successfully removed the bearing, take your time and inspect the area where the bearing will be installed. If you don't feel any burrs, proceed to install the new bearing. If you feel any burrs, gently file them with a rat tail file. Then install new rings and bearings with this tool. BTW, yes, it's not American made, and most importantly, it's aluminum, which means you don't hit it with your hammer, you…