💡 WS2811 16.4ft 60LEDs/m Individually Addressable LED Strip - 5m 300LEDs Flexible Rope Light - Dream Color - White PCB Non-Waterproof DC12V: A Versatile Lighting Solution Review

The adhesion of the 3m tape on the back of the strip is very good. I installed them in aluminum duct when the temperature was only 40 degrees Fahrenheit and they stuck very well! These lights work as advertised. I would definitely buy again!

Figured out how to use uno with Arduino: Positive and negative on the LED strip for 12v supply, ground and data for ground and pin 3 in the unoLoad Fastled library. Change the LED number from 64 to 100 RGB. real person living in New Mexico)

I bought 16 packs, one strand was bad but I already cut it before realizing it. I burned out some pixels in another thread. Overall it's 90% good. The colors are strong and the pixel density is good. That's 3 pixels in a group, I bought another set with half as many pixels and they were too far apart.

I bought this product to finish a 3D printed Nanoleaf clone. After removing the 3M brown backing from the product to stick it, all the sticky part stuck to the brown backing and not the backlight itself, rendering the backlight unusable. Very disappointed with this as I now need to find another product that actually works.

I bought 16 of these kits to use with the Falcon f16v3 in my Christmas light show. One line was bad and the other had 3 dead pixels. The seller sent me 2 new rolls which is great customer service. They look very nice in the show and the color is identical to my pixel lights. It was BRG instead of RBG like in Pixel but I could set it in the controller so it wasn't a problem.

Beautiful and bright overalls. We used these lights for Halloween and they were beautiful and eye-catching. They have a high LED density per meter compared to other products I've used in the past. Couldn't test waterproofing but they have a pretty durable silicone coating. I used zip ties for my application as they had to withstand strong winds. In general a good product.

Good lights so far! I love the black backing so they blend better. Haven't tested adhesion yet but I'm not worried as most LED strips have decent adhesion and if they don't there is always 3m of tape. I found it a little difficult to figure out that there is an "IN" side and an "OUT" side, meaning I accidentally soldered the "OUT" side to the controller pins and nothing happened. But that also means the protection is good, because after I soldered the "IN" side to the controller wires, the…

They work really well and are perfect for my project (general lighting effects). There is one WS2811 driver for every 3 physical LEDs in the chain and EVERY LED is an RBG. This means when you turn on a pixel, 3 LEDs light up. The length of the light bar for a "pixel" is about 3 inches. If you need full color and brightness control for long strings of LEDs, this strip is for you. If you need individual LED addressing, this is not for you. This product is perfect for 12v under cabinet lighting…