💪 Enhance Performance with AEM 2 Gauge Display Set - UEGO WideBand Air/Fuel Ratio Gauge + Boost Pressure Gauge -30-35psi + Get a Free MAPerformance Lanyard! Review

I've only had these sensors for a month but so far they are excellent. Precise, simple and direct assembly, very easy to complete, I would buy again

Purchased on May 27, 2020 This update is on June 6, 2021. Well the first boost sensor was defective from the start. It's been a little over a year since my purchase and the Stock Boost sensor has stopped working. AEM was terrible to deal with last time, so I'll go ahead and just replace those sensors with something else.

check O2 sensor for excessive wear! Ideally, use a safe anti-seize compound on the oxygen sensor, or none at all. The O2 sensor also failed during warm-up, despite the instructions stating "do not leave the sensor in the gas stream without power to the heater”, it is strongly recommended to wait for the condensate to burn off before turning on the sensor , to prevent overheating of the sensor shock. ceramic element. Not sure if it was antiseptic or exhaust condensation as heating up too rich…