🔵 AMVR VR Mask Silicone Protective Cover Set for Oculus Rift S Headset - Blue | Sweatproof, Waterproof, Anti-Dirty Replacement Face Pads Accessories with Front Foam and Rear Foam Silicone Cover Review

The assembly experience is terrible, the "double-sided tape" is actually single-sided, and the convenience is a barely noticeable difference.

I was expecting this product to have shape problems A bit difficult to get through. Great for VR. Feels good. But the most important thing is that there is no sweaty bandage on the head when sharing. Makes cleaning easy.

leaves imprints on the face after using it for more than 20 minutes, and also causes barrel deformation due to the thick front interface. That's good, but maybe they should have done it without fingerprints on the surface.

Honestly, the factory padding is much more comfortable with extended use, but the small sacrifice in comfort is worth it for the longevity of the VR device. Just wipe it off after use. Installation requires some effort, but it's not rocket science. Will definitely buy for other VR devices.

So far I've only installed the interface cover. I have to adjust it from time to time because it doesn't attach to the hooks like the other two pieces, but other than that it works fine. I have to dry my face more often because the sweat is no longer absorbed by the phone. But the foam is no longer cloudy. Today I will put the other 2 pieces.

An excellent set of covers. Because it's silicone it doesn't breathe as well as foam but it's MUCH more hygienic and comfortable for me as I have a shaved head and my stubble doesn't like Rift foam/fabric. It also stays colder than styrofoam. The only thing I have is that the bezel cover doesn't fit very snugly on the bottom so it's not very secure, but it wasn't really a big issue.

It really keeps sweat out of your face. However, that sweat really has nowhere to go until it dries. I would personally recommend a slightly thin headband if like me you are a heavy sweater. Installation was quick and easy as this is a case for the original foam and not a replacement. It is comfortable, easy to clean and has no odor. The best part is that it dries quickly, so after a short break the headset is no longer cold and damp.

3 stars first because I ordered the blue and received the grey. I didn't want to go through the return process and thought the gray looked ok so I'll take care of that. The product was what I was looking for. Sweat is an issue with standard headgear, especially if you're sharing a VR headset. These are covers for the bearing belt. You take the cover off and put it on and then put it back on. They stay in place well. Time will tell how they hold up, for now I think they're worth it.

I received the silicone cases and thanks to other reviews I knew what to expect. What I didn't expect is that the silicone sleeves make the foam stiff. This eliminated the "recoil" of the foam. Yes, it keeps the foam clean and dry. But I still have to use face masks for comfort. Disappointing. I couldn't wear them for more than 15 minutes without a face mask. I had to use a knife to open the slits in the silicone, but after that everything fitted very well. It took 5 minutes to attach…