AutoRight C800906 10 Foam Bonnet Review

They're only good for one use and then they're rubbish. I was waxing 75% of a small Japanese mini truck and the foam broke. I then did the rest by hand.

Wax holds well, does not leave marks, etc. Gently stretch the cap and try to use an elastic band so that the foam does not tear. there were no problems

Matches my 10" Harbor Freight Orbital Buffer perfectly. I was able to wax the whole car without even breaking a sweat. Be careful with the stretching and tearing to put this on as it is very tight but had no problems and for the most part it held up.

This is NOT a 10" pad. That's the 9" I couldn't get on my 10" fender. Went to Walmart and found what I needed and it fits perfectly. Unfortunately it is too late for a return. Don't buy this if you need a 10 inch pad.

Not sure what other reviewers mean when they say this is poor quality. Not quite sure what else they would like. I have used these for my 10" portable Ryobi Buffer and while they are a little tricky to apply (which is a good thing rather than a bad thing) they have been great for waxing and buffing my cars.

Works great on my 10" Harbor Freight Orbital Buffer. I was able to wax the whole car without breaking a sweat. Took the advice of some product reviews, be careful with stretching and tearing his to put this on as it is very tight but had no problems and mostly held up.

I don't usually take the time to write correct reviews as it is difficult to distinguish genuine reviews from fake ones. Please take my warning seriously as I initially ignored others when purchasing this product. Size - other comments were just about how tight and difficult it is to fit this foam applicator on the hood. However, I put it on without tearing it after a minute or two. Functionality - I first wet the foam applicator pad to prepare the applicator for sealing. When you turn on the…