🔌 Battery Tender USB Charger Adaptor: Charge Mobile Devices on the Go with 12V Vehicle Battery - 081-0158 Review

Works as intended. There is no on or off switch, just plug it in and it's on. Suitable for quick disconnect wires on Battery Tender or Battery Minder cables connected to the battery under test. Displays the voltage in digits with one digit to the right of the decimal point (e.g. 12.7V) and one of the small indicators to the right of the LCD will light up. Green = Greater than 12.0V, Yellow = 11.6 to 12.0V and Red = Less than 11.6V. The display voltage range is 3 to 16 volts. The one I received…

Usually remove the seat. Get my multimeter from my tool kit and measure the voltage. Now I just plug this amazing gauge into the pigtail socket and it tells me what I want to know without removing the seat. For most cars/trucks/motorcycles you need at least 12.5V when idle. When idle means the car was NOT started for at least 12 hours before you took the reading. The reason is that when you start and run your car, the alternator is charging the battery and the reading will be higher because the

I wanted to connect something to my bike and check the battery voltage on it from time to time. My bike tends to drain my lithium battery and then it is very difficult for me to recharge the battery. So I bought this voltmeter and it works very well. You press the button and the voltage value appears on the LCD screen. The light turns green when the charge is within the allowable charge range. The backlight and LCD will turn off after a few minutes to conserve battery power. That's exactly what

GoPro camera adapter required Glad to find this very smart device. I use the Battery Tender on my bike to keep the battery charged when the winter gets too long or I can't ride. I wanted to plug my GoPro into a power source so I could have constant power while driving and record video for long periods of time. I went via this USB quick disconnect from the battery tender and my wish was granted. Since I already had an AC adapter plugged into the outside of my bike to connect the Battery Tender…

I have a restored car that I rarely drive. but often enough to keep the battery connected. I connected this LCD to measure battery voltage using a quick disconnect battery cable with ring pins and attached the cable to the pins on my battery. The cable is long enough to extend about 6 inches in front of the battery, and the monitor rests on top of the coilover strut. Now when I want to check the battery level, all I have to do is press a button and I know immediately whether my battery starts…